SCI的results部分主要聚焦于实验的客观结果，这些结果是在材料和方法部分中描述的研究或分析所得出的。Results部分为读者建立了后续解释和评估的Discussion部分的基础，以决定这些结果是否足够支持研究假设。
在撰写SCI论文的Results部分时，需要遵循一些写作原则。首先，要按照和引言、方法部分里一样的顺序来对结果进行排序，以避免读者阅读过程中的混乱。所呈现的数据应支持讨论部分中将会提到的所有结论。同时，可以用数据插图（如图表和表格）来替代或取代部分文字，以更直观地展示研究结果。在阐述研究结果时，一般采用过去时，而具体说明结果时则多用现在时。当图表作为主语时，常采用一般现在时，并多以被动语态书写结果。
值得注意的是，Results部分不能包含作者的偏见或对结果的解释，也不能将其置于先前研究的背景中。它应该仅仅呈现实验结果，让读者能够自行判断这些结果的意义和价值。
as anticipated is/are better than
as expected, is/are in good agreement
as predicted by ... is/are identical (to)
as reported by ... is/are not dissimilar (to)
compare well with is/are parallel (to)
concur is/are similar (to)
confirm is/are unlike
consistent with match
contraryto prove
corroborate refute ·~
correlate reinforce
disprove support
inconsistentwith validate
in line with verify
应用实例
• It is evident that the SFS results obtained here are in exceptionally good agreement with existing FE results.
• Distributions are almost identical in both cases.
• Our concordance scores strongly confirm previous predictions.
• We see that the numerical modeltends to give predictions that are parallel to the experimental data from corresponding tests.
• These results demonstrate that improved correlation with the experimental results was achieved using the new mesh.
• This is consistent with results obtained in [I].
• The results are qualitatively similar to those of earlier simulation studies.
• These trends are in line with the previously discussed structure of the of
the ferrihydrite aggregates.
转自小憨憨同学微信公众号，仅作学习交流，如有侵权，请联系本站删除！
